SECEUROGLIDE...
BETTER AT EVERY STAGE
|
|
|
|
OPERATION
Opening
the garage without leaving your car will keep you dry
and secure, whilst vertical operation allows you to park
right up to the garage door without wasting valuable drive
space.
|
CONSTRUCTION
Achieves
maximum drive-through height to accommodate off-roaders
and people carriers. The individual aluminium slat construction
is exceptionally strong yet can be easily repaired if
damaged.
|
|

|

|
|
DESIGN
Our roller design frees valuable overhead storage space
which is wasted by traditional up-and-over or sectional
garage doors. There is no need for keys as it locks automatically
when closed.
|
INSULATION
Our tough double skin curtain is insulated with high density
CFC-free foam to reduce heat loss and sound transmission.
An innovative brush seal achieves superior draught proofing.
|
(1)
Face Fix - Installation
Here
the inside edge of the guide rails line up with the brick opening.
However the flush fitting end plates and flat design of the
guide rails make the size of the door and positioning of the
guide rail less critical. A subframe is not required unless
the structure is very uneven. Moreover, if maximising the width
of the opening is not important, an existing subframe can be
retained with the door installed in line with the timber opening.
If required the guide rails can overlap into the opening by
up to 25mm on each side.
(2)
Reveal Fix - Installation in the Door Opening or Between Walls
If
the door is manufactured to the exact opening width, it can
be installed within the aperture. This may also depend on the
available headroom above to accommodate the coil. If the coil
is going to be visible from the outside, an external 90O facia
will be required.
(3)
Headroom Requirement
The small coil diameter is one of SeceuroGlide’s strengths.
Just 300mm headroom is required inside the garage for doors
up to 2500mm opening height and 350mm for doors up to 3500mm
opening height.
Where
the available headroom is severely restricted SeceuroGlide Compact
requires just 205mm headroom for doors with an opening height
up to 2300mm. Alternatively SeceuroGlide Compact can be fitted
externally. We strongly recommend that a minimum 55mm of bottom
slat should hang down into the guide rails when the door is
fully raised. Below this is the “drive through height”.